9/1/2023 0 Comments Asus prime fan control![]() ![]() But sometimes, the fans might spin at a high RPM by default, which can cause the system to get noisy. ![]() Generally, they spin at different RPMs (Rotation Per Minutes) depending on the load on your system. Also make sure that the board is getting real RPM values from fans (splitters and hubs can break this) and the tuning settings are per header, so all used headers need to get good rpm readings for tuning to work.The fans inside your computer keep the component and the system cool. I also vaguely remember that it resets if it detects fan configuration changes (like plugging to different headers). Also the "pump" fan header has different limits for some reason so try not to use it for fans if possible. Since this is for someone else, who will probably not update their bios on their own, it should be safe, as the settings are remembered (unless you reset the bios or update it). I usually run it 2-3 times until I get the numbers I know are possible. After each "tuning" check the what is the new min duty cycle it will allow you to set. ![]() In your case I would try running it again, maybe even have the case opened up and "help" the fans to spin during the test cycle - either by blowing air in to them or by hand. It does this by running the fans slower and slower and checking reported RPM. The tuning part tries to figure out the minimum startup voltage for your fans and the bios will not allow you to set speeds below that (if you never ran the fan tuning it uses the default limit of 60% for DC and 20% for PWM). You need to run the fan tuning to set DC fans below 60% and PWM fans below 20%. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |